Hello Wiring!

by Juan Pablo García Sossa
Simple example to try your Skintimacy with Wiring.


Hello Wiring! is a simple example to start using your Skintimacy with a Wiring board. In this case, Skintimacy will be used to turn the WiringLED on and off depending on the touching measures.

You can download the code here: HelloWiring
Alternatively, you can download a calibrated version here if you’re having problems with your readings: HelloWiringCallibrated

SkintimacyWiringYou will need to connect your Skintimacy to your Wiring Board as shown. In this case you will only need to use Player 1 and Master to turn on the WiringLED.

You will need a 9v Battery, two (2) Crocodile Clips, some wires, your Wiring Board and of course your Skintimacy.ConnectionClose

Notice that In- on your Skintimacy, goes to Wiring’s GND and to the Battery - Yellow

While In+ goes just to the Battery +
Red  Battery

Player1 should hold in this case the blue wire’s end and the Master the green wire’s end

Skintimacy players are connected to Analog In on your Wiring. When Player1 and Master touch each other, the WiringLED should turn on.Wiring